Fiat 500 Replacement Key Fob

It might be time to change the battery if your 500 remote key fob isn't working. If you replace the battery, but it still doesn't work it could be a problem somewhere else.

United Locksmith specializes in the creation of new keys for classic cars. We have all of the necessary tools and parts for this type of service.

Dead Coin Battery

The most frequent reason that your Fiat 500 key fob will not lock or unlock the doors is due to a dead battery. The battery of the coin cell inside the key fob can be depleted quickly if you don't use it frequently enough. If your remote starts to show signs of loss of range, or has stopped functioning, then the battery may be dead.

Metal clips keep the battery in place on the key fob. If the clips aren't tight, they can cause problems with the contact, which can stop your remote to receive power. With a small flathead screwdriver, pull the retaining clip open to remove the current battery and then insert a fresh one. Be sure to choose an alternative battery that has the same type of voltage, size, and specification as the original battery.

Water exposure can cause the key fob to corrode or be damaged. Even a quick bath in warm, soapy water can damage the chip. Keep your key fob dry.

Water Damage

If your key fob isn't working correctly, it could be caused by water damage. Key fobs are fitted with rubber seals that prevent them from being damaged by rain or splashes of water, however it is vital to keep your car keys away from the pool, ocean and the washing machine!

The key fob has an electronic chip that sends a signal to your car's immobilizer system. This is the reason why your 500 can lock or start, but in the event that the chip becomes wet, it's unable to longer function.

If you want to check if your key fob is functional you can clean the internal electronics using isopropyl or an electronic cleaner. It is best to replace the key fob if it's submerged in salt water, rather than trying to repair it yourself.

While a replacement fob can cost a bit of money, it's a lot cheaper than paying for your Fiat multipla key (Miller-larsen-2.technetbloggers.de) 500 to be towed to the dealer and repaired! You can also make it yourself by following only a few steps. Be sure to have the correct type of battery before attempting to open your keyfob. This task is much simpler than it appears and you can find step-by-step instructions online for nearly every car key fob.

Faulty Chip

The chip in the key fob is in direct communication with the immobiliser on your car to ensure that your vehicle will only start when the right keys are in place. If the chip is damaged or Fiat Multipla Key damaged it won't allow your car to start, no matter what you do.

A chip that is damaged can happen due to many reasons, but most commonly due to water damage or the battery being dead. Regardless of the reason, it is a good idea to leave the work to a locksmith, as they will be able to repair the chip quickly and at an affordable price.

If your key fob ceases to function after exposure to clean water from the tap or rain, remove the battery and wipe down the electronic component with a tissue to ensure that it is completely dry before putting it back into. If the key fob doesn't work it's likely to be to be a damaged chip that will require replacement.

Some people will go to their dealer when they require a new Fiat fob. However, this could be expensive. United Locksmith is the best option for you if would like to have your Fiat key fob repaired at a reasonable cost. We have all the equipment and know-how to repair your fiat doblo key fob programming fob in a timely and professional way.

Faulty Receiver Module

Fiat key fobs transmit an electrical signal to the vehicle, which will unlock and close doors (and start the car for vehicles with an automatic transmission) up to 50 feet. There are a variety of reasons why a fob could not function. This includes a dead battery water damage, worn out buttons an issue with the receiver, signal interference or malfunctioning chips.

If the fob was in a pocket which has endured extreme trauma, such as being dropped on hard floor or being washed in the washing machine, it may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is an extremely secure system that will only accept a signal from a genuine key and not another.

If this is the case, you must replace your fob. A locksmith professional can handle all aspects of the replacement procedure and even program a new one for your 500. In fact, they can offer you a clone key that works just the same way as the original fob (and costs only a fraction of the cost).